Dp Dual Trac 20 Assembly Instructions Full May 2026

Visual check: Both cables should move freely without crossing. The pulleys must rotate in the same plane (no diagonal pull).

Pro tip: Before full tension, thread each cable through its pulleys with the carriages removed. Then install carriages over the cables.

This is the machine's defining feature and the trickiest part of the assembly.

Time: 20 minutes

Now, go back and tighten every single bolt starting from the base upward. dp dual trac 20 assembly instructions full

Weight Stack Tension:

Pulley Alignment:

Lubrication:

Objective: Connect the uprights and add the pull-up station. Visual check: Both cables should move freely without

Inspection: Pull gently on the crossmember. It should not shift or creak.

The DP Dual Trac 20 arrives in two heavy cartons (Main Frame + Weight Stack). Before you begin, clear a floor space of at least 10ft x 10ft.

Main Components (Verify against your packing list):

Pro Tip: Sort hardware into small bowls or a magnetic tray. Label them using the sticker sheet often provided in the manual. Pro tip: Before full tension, thread each cable

Model: DP Dual Trac 20
Document Type: Full Assembly Manual
Revision: 1.0

If your DP Dual Trac 20 is the plate-loaded version (not selectorized), skip to Step 5.

For selectorized units:

Caution: Do not force the guide rods. Lightly oil them before assembly.