Exergear X10 Cross Trainer Manual Better Online

  • Connect console cables (upper to lower wire). Snap console onto the bracket.
  • Insert batteries (2x AAA, not included) into console back.
  • Check all bolts again before first use.

    • Visual diagram on Page 4 of the printed manual (refer to QR code for video).

    | Problem | Likely cause | BETTER fix | |--------|-------------|----------------| | Pedal slip | Belt loose | Adjust belt tension via rear bolt (2.5mm hex) | | Clicking sound | Pedal crank bolt | Remove pedal, apply blue Loctite, torque to 40 Nm | | Console not turning on | Batteries low | Replace 2x AAA and check wire harness connection at base | | Resistance not changing | Magnet gap too wide | Set magnet-to-flywheel gap to ~1.5mm (credit card thickness) |

    Most errors on the X10 stem from poor assembly. Here is the "Better" way to build your trainer. Exergear X10 Cross Trainer Manual BETTER

    Here is where the Exergear X10 Cross Trainer Manual BETTER differs. Do not fully tighten any bolts until all four pedal arms are attached. Why? If you tighten the left side first, the right side will bind. Finger-tighten everything, align the crank arms parallel to the floor, then torque down.

    | Problem | Likely cause | Solution | |---------|--------------|----------| | Console not turning on | Batteries dead or loose | Replace 2x AAA / check polarity | | Clicking noise from pedal | Loose pedal bolt | Tighten with included wrench | | Uneven rocking | Floor not level | Adjust rear stabilizer knobs | | Jerky resistance | Lack of lubrication | Apply lubricant to axle joint | | Pulse not showing | Hands too dry / moving | Grip sensors firmly & stay still for 10 sec | Connect console cables (upper to lower wire)

    Congratulations on choosing the Exergear X10 Cross Trainer. Designed for low-impact, high-efficiency cardio, the X10 helps you burn calories, improve heart health, and tone lower body muscles—all from home.
    Please read this entire manual before assembly or use.

    The manual says you need a chest strap for accurate HR. BETTER advice: The X10 handles Bluetooth dongles. Plug a Bluetooth 4.0 dongle into the USB port (if available on your model) to connect to Peloton or Zwift. The manual doesn't tell you this, but it changes your cardio life. Visual diagram on Page 4 of the printed

    | Frequency | Action | |-----------|--------| | After each use | Wipe down sweat from frame, pedals, console. | | Weekly | Check bolts on pedals and swing arms. Tighten if loose. | | Monthly | Apply supplied lubricant to pedal crank joints and sliding rail (if equipped). | | Every 3 months | Inspect power wires and pulse sensors. Replace batteries. |

    Do not use WD-40 – only silicone-based lubricant or the supplied oil.

    Recent