Conecta con nosotros

F4901 11a 24v Schematic Install - 

AC INPUT (120V/230V)          F4901 PSU              DC LOAD (11A max)
   L (Hot)   ----------------> L/IN                    +24V ----> LED Strip (+)
   N (Neutral) --------------> N/IN                    COM  ----> LED Strip (-)
   GND (Earth) --------------> PE (if present)         (Load draws ≤11A)

Installation Steps (PSU mode):

If the schematic shows a diode symbol, reversing A1/A2 will short your power supply.

If you are installing a fuel level sensor or an immobilizer relay: f4901 11a 24v schematic install

The F4901 11A is typically an advanced GPS tracking terminal designed for fleet management, logistics, and heavy machinery. It is commonly used in commercial vehicles (trucks, buses) which utilize 24V electrical systems.

Key Features typically include:

At 11A, conduction loss = I² × Rds(on) = 121 × 0.012 = 1.45 W. With RθJA ~ 45°C/W (natural convection), temperature rise ≈ 65°C above ambient. For 50°C ambient, case temp = 115°C (acceptable for industrial grade). For higher ambient, forced air or reduce current to 9A.

Disconnect the main negative terminal from the battery bank. 24V systems can arc significantly if shorted. AC INPUT (120V/230V) F4901 PSU DC LOAD (11A

A standard harness usually consists of a main connector with 8 to 12 wires.

| Wire Color (Typical) | Function | Description | | :--- | :--- | :--- | | Red | Power (+) | Connect to Constant 24V Power (Battery Positive). | | Black | Ground (-) | Connect to Vehicle Chassis Ground or Battery Negative. | | Yellow | Ignition (ACC) | Connect to the vehicle's ignition key switch (24V when key is ON). | | Orange | Relay Output | Used to control an external relay (e.g., fuel cut-off/immobilizer). | | White | CAN High | Connects to Vehicle CAN Bus High line. | | Green | CAN Low | Connects to Vehicle CAN Bus Low line. | | Blue | Digital Input 1 | Typically used for SOS button or Door sensor. | | Other Colors | Analog/Input | Used for fuel sensors or temperature sensors. | Installation Steps (PSU mode): If the schematic shows

Note on the "11A" Designation: This often refers to the current rating or a specific firmware/hardware revision. Ensure the wiring harness gauge supports the current draw of the device and any connected peripherals.