You cannot do this with software alone. Gather these items:
Warning: If you do not have a matching ISP_Code.bin and ISP_Data.bin for your specific NAND (Toshiba, SanDisk, Intel), do not proceed. Using wrong firmware will corrupt the NAND's bad block table permanently.
If successful: In MPtool, the device list will refresh and show a device with "Ready" status but 0MB capacity. If you see "Timeout" or nothing, repeat. Adjust timing—some FC1178BC need the short held for exactly 1.5 seconds after plugging. firstchip fc1178bc firmware hot
The good news? The Chinese tooling community (UmpcFans, USBDev) has released hot-off-the-press firmware updates that address the thermal management on the FC1178BC.
What the new firmware improves:
The FirstChip FC1178BC is a budget USB 3.0 controller found in many no-name flash drives (Silicon Power, PNY, or generic eBay specials). While cheap, it has a notorious flaw: it runs extremely hot.
Under sustained write loads, the controller can reach 70-85°C. When the firmware detects this "hot" zone, it initiates thermal throttling, dropping speeds from 100 MB/s down to 5 MB/s. Worse, if the firmware is outdated, the drive may simply disconnect, leading to corruption. You cannot do this with software alone
Even with the short, you might encounter errors. Here is what to do:
| Error | Solution | | :--- | :--- | | Device not detected after short | Reverse the tweezer pins. Short for 5 seconds instead of 2. Try a different USB port (USB 2.0 works better). | | "Download Firmware Fail" | Your firmware file is wrong. Extract the NAND ID manually using a tool like "ChipGenius" on a working PC, then search for that exact ID. | | "Bad Block too many" | The NAND is dying. Reduce the drive's capacity in MPtools by setting "Auto Detect Size" to manual (e.g., force 32GB instead of 64GB). | | Drive reverts to 0 bytes after replug | You forgot to check "Fix Capacity." Reflash with that option enabled. | Warning: If you do not have a matching ISP_Code
The search term "FirstChip FC1178BC firmware hot" typically refers to "hot-swappable" firmware modification tools or mass-production (MP) tools that allow users to forcibly reprogram the firmware of a USB flash drive controller without soldering. These tools are widely sought after to repair corrupted USB drives or to remove "write protection" errors. However, recent intelligence indicates these tools are also increasingly used in fraudulent activities (fake capacity drives) and pose significant data security risks.