Life Probo Pr70 Instructions For Installation Use And Maintenance Manual 10 Pages Upd Instant

2. TECHNICAL DATA

| Parameter | Specification | | :--- | :--- | | Model | Life Probo PR70 | | Voltage | 220-240V AC / 50-60Hz | | Power Consumption | 70W (Nominal) | | Maximum Current | 0.35 A | | Speed Settings | 3 Levels (Low / Medium / High) | | Airflow Capacity | Up to 850 m³/h | | Noise Level (Max) | 45 dB(A) @ 3m | | IP Rating | IPX4 (Splash Protected) | | Operating Temperature | -10°C to +40°C | | Material | High-Grade ABS Polymer / Steel | | Net Weight | 4.5 kg | | Dimensions (HxWxD) | 350 x 400 x 200 mm |

Standards Compliance: This product complies with CE, RoHS, and relevant ISO safety standards.

Unpacking:

Placement:

Power connection:
Plug adapter into rear DC jack → wall outlet. LED will flash blue.

Mounting (optional):
Mark 2 holes 80mm apart. Use 6mm drill bit. Insert anchors. Attach bracket, then snap PR70 into place.

First boot:
Press power button for 3 seconds. Display will show firmware version, then "READY".

Weekly External Cleaning

Monthly Descaling (if water hardness > 120 ppm)

Cleaning the Nozzle/Spout

Long-term Storage ( >1 month)

| Problem | Probable cause | Solution | |---------|----------------|---------| | No power | Adapter unplugged | Check outlet, reconnect | | Erratic readings | Movement during test | Repeat without talking | | "Err 1" | Cuff too loose | Refasten and restart | | "Err 4" | Battery low | Charge 2 hours | | Bluetooth fails | Device out of range | Move within 5 meters | | Display shows "CAL" | Calibration overdue | Contact service center | Unpacking:

Factory reset:
Press MENU + POWER for 10 seconds until display flashes "RESET".

WARNING:

Intended use:
Home or clinical monitoring of [specify – e.g., blood pressure, oxygen saturation, weight].

Contraindications:
None known when used as directed. Placement:

Symbols explained:

The PR70 has a self-diagnostic system, but physical checks are required.