Methameasure: User Guide

To prevent sensor failure and maintain warranty validity, adhere strictly to this schedule:

| Frequency | Task | Tools Required | | :--- | :--- | :--- | | Daily | Check for condensate in the sight glass. Push the drain button. | None | | Weekly | Verify flow meter ball is floating at 0.8–1.2 L/min. Adjust needle valve if needed. | Flathead screwdriver | | Monthly | Remove the internal dust filter (under front cover). Wash with distilled water, air dry. | Hex key (3mm) | | Quarterly | Full zero & span calibration (see Part 5). | Calibration gases | | Annually | Replace the NDIR light source (factory service only). | Return to vendor |

Critical Warning: Never use high-pressure compressed air (over 2 bar) to blow out the internal manifold. Use only low-pressure nitrogen or sample gas. Excess pressure will rupture the micro-flow sensor (cost: ~$400 USD for replacement).

In the mobile app, swipe an alert to Acknowledge (you are investigating) or Snooze (temporary, with a note). Acknowledged alerts are timestamped and logged for audit trails.

The goal of the MethaMeasure reporting suite is to turn raw field data into actionable insights. A "Useful Report" is defined here as a document that provides accurate summation, volume calculation, or compliance data that can be shared with stakeholders, mills, or inventory managers.

| Issue | Likely Cause | Solution | | :--- | :--- | :--- | | Report is blank | Date range is incorrect or no data synced. | Check internet connection on the field devices; verify the date range covers the harvest dates. | | Volumes look wrong | Incorrect Formula applied. | Check the "Settings" or "Species Configuration" to ensure the correct Volume Equation (e.g., JAS, Huber, Doyle) is selected. | | Missing Loads | Data not uploaded from the scaler device. | The field operator needs to force a "Sync" on their mobile device/tablet. | methameasure user guide

The MethaMeasure User Guide provides essential instructions for operating their automated methadone dispensing system, which is designed to improve pharmacy safety and speed . The guide covers initial setup, patient management, daily dispensing, and maintenance . 1. Getting Started: Setup & Priming

Before dispensing, the system must be logged into and the pumps primed to ensure accuracy .

Logging In: Double-click the MethaMeasure Icon and select the responsible pharmacist's name . Priming: Turn the pump on and place a cup under the nozzle . Click Prime Pump to clear any air or cleaning fluid .

Insert the methadone bottle, ensure the tube is positioned, and prime again until the tube is filled with methadone . 2. Calibration & Accuracy

Accurate calibration is critical for maintaining correct stock levels and patient safety . To prevent sensor failure and maintain warranty validity,

Process: The system will request 100ml, 50ml, and 10ml test doses . You must enter the actual volume measured in a glass measure into the software .

Tips: Use a high-quality glass measure (plastic is not recommended) and read from the bottom of the meniscus on a level surface . 3. Patient & Prescription Management

New Patients: Add patients via the plus (+) symbol, including their name, address, and a photograph or fingerprint for biometric ID .

Prescriptions: Enter details exactly as they appear on the prescription, specifically selecting collection days (DD) and take-home doses (TH) . 4. Daily Dispensing Workflow

Dispensing: Select a patient and click Begin Dispensing . Verification occurs via picture or fingerprint recognition . In the mobile app, swipe an alert to

Verification: The system dispenses the dose and automatically records the entry in the electronic Controlled Drugs (CD) register .

Advanced Prep: You can prepare doses in advance by using the Advance Preparation tool, though they must be stored securely in the CD cabinet until collected . 5. Maintenance & Cleaning User Guide | MethaMeasure

Create metrics beyond standard analytics:

To add: Settings → Custom Data → + Add Custom Metric/Dimension
Then push data via methaMeasure('track', 'event', metric_name: value ).