The Orbitor Prospector 100 is a Very Low Frequency (VLF) detector optimized for coin shooting, relic hunting, and gold prospecting in mild to moderate ground conditions. Before we dive into the controls, familiarize yourself with the hardware:
Note from the manual: “The Prospector 100 is not fully submersible. The control box is weather-resistant but should not be immersed in water.”
Look for:
This write-up summarizes typical features, setup, operation, troubleshooting, and best practices for the Orbitor Prospector 100 or similarly specified VLF hobby detectors. For exact specifications, detailed diagrams, firmware-specific menus, and official warranty or service contacts, refer to the original printed manual or the manufacturer's official documentation.
Related search suggestions: "suggestions":["suggestion":"Orbitor Prospector 100 manual PDF download","score":0.94,"suggestion":"Orbitor Prospector 100 specifications and user guide","score":0.82,"suggestion":"best settings for Orbitor Prospector 100 beach detecting","score":0.64] Orbitor Prospector 100 Metal Detector Manual
Orienting yourself to the dials is critical. The Orbitor Prospector 100 uses three primary rotary knobs and one push button.
| Control | Label | Function | | :--- | :--- | :--- | | Left Knob | VOLUME (PWR) | Turns the unit On/Off and adjusts speaker volume. | | Center Knob | DISCRIMINATION | Eliminates junk metals (iron, foil, pull tabs). | | Right Knob | SENSITIVITY | Adjusts how deep and how small a target is seen. | | Red Button | TUNE (Pinpoint) | Manual retune and momentary pinpoint mode. | The Orbitor Prospector 100 is a Very Low
Analog Meter: The needle swings from left (Ferrous/Iron) to right (Silver/Copper). The colored zones are: