Point-n-measure Digital Tape W5746 User Manual -

The reference point determines where the measurement starts from.

| Mode | Icon | Use case | |------|------|-----------| | Front | 📍 Front | Measuring from the front edge of the device into a corner. | | Back | 🔙 Back | Measuring from the rear of the device (against a wall). | | Pivot | ⚙️ Pivot | Using the tape hook as the zero point (same as standard tape). | Point-N-Measure Digital Tape W5746 User Manual

To change: Press REF repeatedly until the desired icon appears on screen. The reference point determines where the measurement starts

Thank you for purchasing the Point-N-Measure Digital Tape W5746. This device combines a traditional retractable tape measure with advanced laser measuring technology. It is designed to provide fast, accurate measurements for distance, area, and volume, making it an essential tool for contractors, carpenters, and DIY enthusiasts. Thank you for purchasing the Point-N-Measure Digital Tape

| Issue | Solution |
|-------------------------------|----------------------------------------|

| Problem | Possible cause | Solution | |---------|----------------|----------| | Laser turns on, no reading | Target too reflective / dark | Use target plate or measure to non-reflective surface | | Display shows Err 2 | Signal too weak | Stabilize device, measure from tripod or solid surface | | Tape won't retract | Dirt or twist in blade | Gently pull out fully, wipe clean, guide back in | | Display faint | Low battery | Charge using USB-C | | Wrong units | Unit mode changed | Press UNIT until correct format appears |