Sokkia Prolink Version 115

Note: Sokkia no longer officially distributes v1.15 via public portals, but you can request it from regional dealers or archived service CDs. Ensure you scan any legacy installer for malware.

Sokkia ProLink Version 1.15 is a dedicated firmware upload, configuration, and data transfer utility for Sokkia’s GNSS receivers, specifically the GCX2 and GCX3 series. Unlike all-in-one field software, ProLink focuses on one critical task: acting as a reliable bridge between your Windows PC and the receiver. sokkia prolink version 115

A common question is: Should I use ProLink Version 115 or upgrade to MAGNET Field? Note: Sokkia no longer officially distributes v1

| Feature | ProLink Version 115 | Sokkia MAGNET Field | | :--- | :--- | :--- | | Target Hardware | FC-200, FC-500, Allegro CX, Older Rugged PDAs | FC-6000, FC-5000, Android/iOS devices | | Learning Curve | Moderate (Traditional interface) | Steep (Modern ribbon UI) | | Robotic Control | Excellent for SRX/iX series | Excellent, plus newer GCX series | | Price | Lower (Legacy licensing) | Higher (Subscription model) | | Support | Discontinued by Sokkia. Community/Forums only | Full manufacturer support | On your PC: Open ProLink v1

Verdict: Stick with Version 115 if you are using older hardware (FC-200/FC-500) and do not need cloud synchronization. Upgrade to MAGNET if you require drone data integration or cloud-based collaboration.

  • On your PC: Open ProLink v1.15. Go to Setup > Communication Port.
  • Handshake: Set Flow Control to Hardware (RTS/CTS). Do not use "None"—this will corrupt large data transfers.
    • Share it
    X