Up0104s Datasheet Direct

Functionally, the uP0104 consists of:

| Symptom | Likely Cause | Datasheet Checkpoint | | :--- | :--- | :--- | | No output, VCC present | IC in UVLO or disabled | Measure EN1/EN2 (Pins 13 & 5). Must be >2.0V. Check VCC >4.3V (Pin 4). | | Output voltage too low | Feedback divider wrong or output short | Verify FB pin voltage (Pins 1 or 14). Should be exactly 0.8V. If lower, output is shorted or divider is incorrect. | | MOSFETs burning hot | Cross-conduction or wrong frequency | Check UGATE and LGATE dead-time (requires oscilloscope). Replace with matched MOSFETs from datasheet spec. | | Intermittent startup | SS capacitor leakage or unstable COMP | Inspect the soft-start capacitor (Pin 3 for Ch2, shared for Ch1). Leakage here prevents ramp-up. | Up0104s Datasheet

Both channels use an internal 0.6V reference.
VOUT = 0.6 × (1 + Rtop / Rbottom) Functionally, the uP0104 consists of: | Symptom |

Example: For 1.8V (DDR VDDQ), use Rtop = 2kΩ, Rbottom = 1kΩ. | | Output voltage too low | Feedback

If you are integrating the UP0104S into a new PCB, the datasheet offers critical layout guidelines.