| Parameter | Value | |--------------------|--------------------------------| | Model | XMK-010 | | Input Voltage | DC 12V ±10% | | Power Consumption | 15W max | | Operating Temp | -10°C to +50°C (14°F to 122°F) | | Dimensions | 180 x 110 x 45 mm | | Weight | 0.65 kg | | Interface | USB 2.0, HDMI out, RS232 |
The XMK-010 communicates via a standard serial interface using a Command Frame Structure. xmk-010 manual
| Symptom | Likely Cause | Immediate Action | |---------|--------------|-------------------| | No display / dead unit | Battery depleted or protective latch triggered | Connect external 12 V DC source; if still dead, open service panel and check for blown fuse (F1) | | Err 0xA3 – Sensor timeout | External probe cable fault | Inspect connector for corrosion; replace cable if needed | | Wi‑Fi not connecting | SSID/password mismatch or antenna obstruction | Verify network credentials; reposition device; reset network stack via Menu > Reset > Network | | Data logging stops after 2 GB | Flash wear‑level threshold reached | Perform firmware update (OTA) to trigger flash wear‑levelling; if persists, replace internal SSD (part #XMK‑010‑SSD‑01) | Define one or two alarm thresholds
Each error code includes a binary breakdown and a link to the corresponding service bulletin. 8 data bits
Define one or two alarm thresholds. For example:
Version 1.0 | Effective Date: [Insert Date]
Slave address range: 1-247. Default baud rate: 9600, 8 data bits, 1 stop bit, no parity. Use a Modbus scanner (e.g., QModMaster) to read holding registers.
Key registers (from the manual):