The increasing complexity of automotive electronics and the need for standardized diagnostic communication protocols have led to the development of ISO 13480. Specifically, Part 4 of this standard, ISO 13480-4, focuses on diagnostic communication over Controller Area Network (CAN) for road vehicles, with an emphasis on requirements for emissions-related systems.
The document provides guidance on the implementation and use of SI units. It is widely used by engineers, scientists, and technical writers to ensure consistency in measurement units.
It is important to note that no free, legal version of the 13480-4 PDF exists. ASME (American Society of Mechanical Engineers) holds the copyright. Distributing unlicensed copies violates copyright law and may expose you to liability if your design is based on an outdated or altered document. 13480-4 pdf
The standard acknowledges certain non-SI units that are acceptable for use alongside SI units due to their widespread usage or legal status.
You cannot get a free PDF of ISO, EN, or ASTM standards legally without purchase. To obtain the official PDF: The increasing complexity of automotive electronics and the
This is the most probable document you need. Here is a summary of EN 13480-4:
| Aspect | Detail | |--------|--------| | Full Title | Metallic industrial piping – Part 4: Fabrication and installation | | Scope | Requirements for the fabrication and installation of metallic piping systems (e.g., welding, heat treatment, forming, assembly, inspection). | | Applicability | Pressure piping in power plants, chemical plants, refineries, and industrial systems. | | Key Topics | Welding procedures, welder qualification, non-destructive testing (NDT), tolerances, post-weld heat treatment (PWHT), and documentation. | Note: This standard has been withdrawn and replaced
ISO 13480:1997 (withdrawn) – Polyethylene pipes — Resistance to slow crack growth — Determination of the notch tensile strength.
This standard specified a method for determining the slow crack growth resistance of polyethylene (PE) pipe materials using a notched tensile test.
Note: This standard has been withdrawn and replaced by ISO 18489 (for PE pipes) and other relevant fracture mechanics tests.